20s 30s Hat Display Stand Vintage Maroon Velvet Flex Spring and Pull Cord VFG, Pair of Two
These vintage hat display stands are quite charming! They would have been used in a millinery shop or department store. Most of the springy stands I have seen are painted metal with colorful painted knobs - this pair is completely covered in soft maroon velveteen. - the base, stem, and domed knob. The round base can sit on a flat surface, or it can be slid onto a narrow shelf (no more than 3/4"thick). The stem has a 3" section of coiled spring to allow it to bend, using the corded pull attached to the edge of the knob. The pull has a large wooden bead knotted at the end, also maroon.
Price is for the pair.
| Measurements | Inches | Cm |
| Standing on flat surface | 9.25" | 23.5 |
| Diameter of base | 4.5" | 11.5 |
| Diameter of knob | 2.25" | 5.75 |
Base of knob is black plastic
Condition: Some age-related dust. The velveteen knobs are a bit scuffed, and the nap worn in a few places. See closeups for most prominent scuffs and wear. No fabric tears or other issues noted.
I measure the outside of garments, unless stated otherwise.
For menswear, the chest is measured at armpit level.
For womenswear, the bust is measured a little below armpit level, including the room created by darts or gathers.
Waist will be measured if there is one, and hips are measured about 9" below waist level. Sleeves are measured from shoulder seam or an approximation in the absence of a shoulder seam. Garment length is measured from the back of the neck, unless otherwise stated.
The measurement numbers refer to the garment, not the body inside. For best fit, measure a similar type of garment which fits you well and compare.
If the garment is shown on Josephine, my mannequin, her measurements are 31/24.5/34". Sometimes she wears a padded bra. My live models measurements vary depending on the day and year, and I don't ask them to share that.